Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
454
Views
5
Helpful
1
Replies

ACS Radius AV pair

mj11
Level 3
Level 3

‎10-10-2007 02:45 PM - edited ‎03-10-2019 03:26 PM

Hi

I was hoping someone could point me in the right direction, I am having a problem configuring AnyConnect with ASA 8.02 with Mutable groups as it seems the only way to do this is during authentication, the RADIUS server can push down the webvpn:user-vpn-group attribute. I am unable to see how to configure the ACS to use AV pairs I have enabled the Radius within the ACS but unsure on where to put the value webvpn:user-vpn-group.

Many thanks MJ

Labels:
0 Helpful
1 Reply 1

Jagdeep Gambhir
Level 10
Level 10

‎10-10-2007 04:44 PM

MJ,

You need to use radius attribute 25. It is configured in user/group setup (either place depending if you want to lock a single user, or a whole group into a tunnel group)

Regards,

~JG

Customers Also Viewed These Support Documents