10-21-2010 05:56 AM - edited 03-10-2019 05:30 PM
Hi Guys,
I have entered all the details for my snmp server;
Host
Community String
Port
Contact
Location - (Left this blank)
However when I trace on my firewall I see snmp coming from my server but the ACS send nothing back.
I am presuming the location is not a compulsary field??
Hence what else can I check or should it just function as long as all the details are correct.
Thanks
Scott
10-25-2010 08:21 AM
Hi Scott,
What ACS version are you using?
If it's - as I think - about ACS 4.x Solution Engine, please check the following page for guidance about the configuration:
The Location itself is not a mandatory field, just make sure that the community and port are correctly set and that you're polling supported MIBs, as specified on the following document:
If you selected Accept SNMP packets from select hosts then make sure that the SNMP queries are coming from an address listed on that field, or try to disable this option for testing.
On the other hand, if it's about ACS 5.x, please refer to the following documents:
* SNMP Agent config:
* Supported MIBs:
I hope this helps.
Regards,
Federico
--
If this answers your question please mark the question as "answered" and rate it, so other users can easily find it.
05-31-2012 01:17 AM
Could you please send me how I can add a SNMP community string on Cisco ACS 5.2 ( Web Based )?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide