ACS testing problem

[c_kumar001]

Hi,

I have acs server installed on windows 2003 server. I am using 2 nic , sometimes it pings to the server address but testing is fail.

It shows no authoritive response from server. When I restart my pc it starts testing again.I think its two nic problem.

Can anyone suggest me another way of doing  the successfull test without restarting my pc.

Plz Help me.

[Tarik Admani]

Chandan,

The guide explains how this was tested using one nic, are both nics plugged in when you perform your test?

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_windows/4.2.1/Installation_Guide/windows/install.html#wp1041506

If so, please unplug one of the nic cards, reboot and see if this fixes your issue.

Thanks,

Tarik Admani

[c_kumar001]

Yes, both nics are plugged in at the time of testing.Conectivity test is successful but protocol testing donot work

[c_kumar001]

Single nic works well ...but problem is that i cannot unplug another nic and reboot . Isnt there any other way ..I tried to restart from ACS>system configuration>service control. but still it didnt work

[Tarik Admani]

This isnt supported -

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCsr76897

There is a feature enhancment that hasnt been addressed, you will have to reach out to your account team for them to provide a roadmap with regards to this feature request.

Thanks,

Tarik Admani