Network Access Control

Hi, I check on ISE monitoring to see the authentication status, i found out IP and device port left blank. What should i do in order i can track user is connected from wchich access switchport (all switch were join identity\ network device)Somemore, ...

HI Experts,Is there any solution or device are there to do  port blocking????i.e I will configure one policy, if anyone violate that policy, that port automatically needs to block. Then administrator only needs to enable that port.For example i will ...

Hello, I have configured ACS 5.1 and using Tacacs. I have two juniper SSG140 FW's in different subnet. Tacacs authentication is working on one SSG140 FW, but not on the other one. Tacacs configuration on both FW's are exactly the same. Both FW's have...

Hello Everybody,I installed NGS 2.0.2 for wireless guest user management and authentication. I implement webauth via webauth page on wlc deployed.One Branch with a WLC5508 version 7.0 wireless anchor controller is working on the NGS.But now I integra...

I'm trying to figure out how to put this lot together, but dont know enough about ACS when used with an external CA.What I want to get working is:A PC with a machine cert gets connected to a switch running 802.1x. The switch uses EAP with .1x to quer...

Hi All,I am stuck a place where i need to select mulitple users from identity group and multiple devices from multiple ndg. situation become worst when i hv two different level of access for the users which are in same ad group but have different acc...

Hi, We have a problem with 802.1x configuration via IP Phone.PC (win7 with certificate)-------IP Phone (7911, 9.2.1s firmware)-----switch (2960, lab base 12.2(58)SE2)Configuration on the port on the switch:interface FastEthernet0/3 switchport access ...

Hi all,I have a pair of physical ASA servers v4.1. Now I need to virtualize them. Do I need to buy any new license? Or I am able to transfer the existing licence from the appliances to the virtual servers.In case I am able to transfer license from th...

Dear Friends, Is there any document to integrate between ACS5.2 and Windows Server 2008R2 for Wireless PEAP Authentication ?Is it possible to acheive authentication to Wireless through two ways 1.ACS 2. NPS (Built-in for Windows Server 2008). In this...

Hi Experts,In my association there is some issue going on with CSACS Device, they have suggested us to upgrade the patch as below..1) ACS 4.2.0.124.9-Fix (Patch:4.2.0.124.9) 2) ACS-4.2.0.124-9-CSUpdate Fix (Patch:4.2.0.124.9) 3) ACS 4.2.0.124.10-Fix ...

Digital certificate on the ACS Wireless network:Checking the configuration of the Wireless Notebook no longer requires the digital certificate of the ACS and NVR122 NVR123as worked in the past.The certificate is generated for the ACS root CA trusted ...

we have 4 ACS in the system:  +) In HQ, we have 2 ACS: 1 primary and 1 secondary ACS+) In Branch office, we have 2 secondary ACSI suppose Primary fail, could one of secondary ACS automatic become primary so all other ACSs can continues replicate from...

Morning everyone,I would like to set up either a TACACS or RADIUS solution here. Wondering what other people have found to be the best server for either of these, preferably free if one exists.Thanks