ACS v.5 cannot be added as secondary via WAN

[larsen_2011]

Hi,

i have planned a deployment with one acs in Europe working as primary, one acs in europe as secondary and one acs in USA as secondary also.

I can add one acs in europe to the deployment as secondary.

When I try to add the acs in USA to the deployment - Nothing really works.

The status shown in the primary is offline (red) and status pending. It stays like this for hours.

When I log in to the gui directly on the acs in USA, it still has status primary.

The two acs are transparently connected. There is WAN optimization (cisco waas) in between the two datacentres...

any hints  or ideas are aprreciated.

thanks

[Jagdeep Gambhir]

Larsen,

Make sure we have these ports open. The ports in question for replication in ACS 5 use tcp:RMI (remote method invocation): ports 2020

and 2030.

Message Bus: 61616 for replication Sybase db (full) replication - while registering or applying full replication uses TCP: 2638.

Regards,
~JG


Do rate helpful posts!