cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

464
Views
0
Helpful
1
Replies
larsen_2011
Beginner

ACS v.5 cannot be added as secondary via WAN

Hi,

i have planned a deployment with one acs in Europe working as primary, one acs in europe as secondary and one acs in USA as secondary also.

I can add one acs in europe to the deployment as secondary.

When I try to add the acs in USA to the deployment - Nothing really works.

The status shown in the primary is offline (red) and status pending. It stays like this for hours.

When I log in to the gui directly on the acs in USA, it still has status primary.

The two acs are transparently connected. There is WAN optimization (cisco waas) in between the two datacentres...

any hints  or ideas are aprreciated.

thanks

1 REPLY 1
Jagdeep Gambhir
Advocate

Larsen,

Make sure we have these ports open. The ports in question for replication in ACS 5 use tcp:RMI (remote method invocation): ports 2020

and 2030.

Message Bus: 61616 for replication Sybase db (full) replication - while registering or applying full replication uses TCP: 2638.

Regards,
~JG


Do rate helpful posts!
Content for Community-Ad