ACS with two IP Address?

[Jairo Sarmiento Garzon]

Hello,

We have the CSACS-1121-K9 chassis running Cisco ACS 5.4, the chassis has four interfaces and I was wondering if I can configure two different ip addresses in different segments to authenticate network devices. This, because we have to manage two different networks.

Thanks.

[Bilal Nawaz]

Hello Jairo, I don't see why this shouldn't work, I haven't tried it myself though.

[alek.gozali · Accepted solution]

i'm using SNS3495 ACS 5.5 , and i already did that,

i had 3 interface ( 1 management CIMC, 1 management ACS ( gui and ssh ) , 1 AAA service )

i believe it would works on your case too,

but we could only had 1 management interface ( for GUI config and SSH)

don't forget to add the static route between networks.