ACS1113 rebuild issue

[mulhollandm]

folks

i have been advised by TAC to rebuild an ACS1113 i have but i need some advice on how to go about it

i have the recovery disk in the cd drive and have rebooted the server but i've lost the appropriate hyperterminal settings and my normal cisco ones don't appear to work

so .....

1. what are the correct hypterminal settings

2. does anyone have a document or link on proper instructions for a rebuild

many thanks to anyone replying

[Jagdeep Gambhir · Accepted solution]

Please check this link for hyper trm setting ,

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_soft/csacsapp/csapp40/igse40/instalap.htm#wp1065399

Here is the link to reimage the appliance

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_soft/csacsapp/csapp40/igse40/admap.htm#wp1045906

Hope that helps !

[mulhollandm]

many thanks for your help

gratefully appreciated