Adding database replication to ACS

[sourcebridge]

I'm installing a backup ACS4.1,The primary server does not have database replication configured on it,

I would like to add this feature, beacuse i need to make it the Primary and replicate it's database to the new backup box i'm setting up, to which i was able to add the feature during the installation.

So i guess my question is: how do i add the database replication feature on Cisco ASC4.1 - post install?

Please help

[Premdeep Banga]

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080742f60.shtml

http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a00800e518a.shtml

Regards,

Prem

[sourcebridge]

Thanks, i've been through these documents already..

The issue is that the primary server is not configured with the replication feature, so it doesn't show up on the "system configuration menu"..withhout this i cannot invoke database replication. but i have this set correctly on the new secondary.

How do i make "ACS internal database Replication" Show up in the "system configuration menu" ?

thanks again?

[Premdeep Banga]

Interface configuration > Advanced Options and check internal database replication.

Regards,

Prem

[sourcebridge]

It was staring right there at me!!!!

Thanks!

[Premdeep Banga · Accepted solution]

Glad could help.

Please mark the thread resolved, so that others can benefit

Regards,

Prem