ASA-1> en Password: ***** , stuck at this point

[Ibrahim Jamil]

Hi 

i am stuck at this point , pls advise , the 9.x OS

ASA-1> sh curpriv
Username : admin1
Current privilege level : 1
Current Mode/s : P_UNPR
ASA-1> en
Password: ***** ---------------------->>>the enable password is cisco , but doesnt work
Password:

Below are the config

aaa authentication enable console ACS LOCAL
aaa authentication telnet console ACS LOCAL
aaa authentication ssh console ACS LOCAL
aaa authentication http console ACS LOCAL
aaa accounting command privilege 15 ACS
aaa accounting enable console ACS
aaa accounting ssh console ACS
aaa accounting telnet console ACS
aaa authorization exec authentication-server

enable password cisco

thanks all

[Dinesh Moudgil · Accepted solution]

Hi Ibrahim,

Seems like your enable password is setup to be fetched from ACS server.
aaa authentication enable console ACS LOCAL

Please check on ACS or reset your password there. If you have console access then remove the command and test.

Regards,
Dinesh Moudgil

P.S. Please rate helpful posts.

[Ibrahim Jamil]

thanks guys , i would go with dinesh  as a helpful answer

[Aditya Ganjoo]

Hi Ibrahim,

You need to use the CVPN3000-Privilege-Level attribute and set that to the level you want. Per the documentation:

http://www.cisco.com/c/en/us/td/docs/security/asa/asa91/configuration/general/asa_91_general_config/admin_management.html#pgfId-1274733

Regards,

Aditya