Network Access Control

My customer is requesting us something I am not very sure is possible.The request is to avoid employees use the devices provided by the corporation to get internet access through the Wireless Guest Service. Currently the Guest Service is already work...

Hello!First, my configuration, (then the problem down below):I have an Aironet 1142 with mulitple SSIDs [mapped to VLANs] connected to Gi1/0/2 on a 2960 switch in a user-accessible area.  This switch is uplinked to another 2960 switch in a wiring clo...

During an upgrade to 1.1.4, one of the Policy nodes didn't deregister successfully. The Primary shows it as now a standalone, but it seems to still be a part of the distributed deployment. I upgraded the Policy node and the rest of the nodes. I tried...

Hi all, just a quick note I wanted to point out for any of the AAA admin folks currently using Active Directory for their external identity store.I'd like to preface this post by saying that I strongly recommend that you purchase the SAS option for y...

after install ACS 5.2.... i tried http://direccionACS/acsadmin couldnt get ti...when i enter the show application status acs command, get:     management   running(http is nonresponsive)how could i fix it?????  i dont have access to the web interface

I am currently trying to configure FWSM to have two factor authentication using RSA. I have configured the ACS and RSA server and everything is ok for routers and switches. What do I need to configure on the firewall side. I have pointed the authenti...

Dear Expert,Im a newbie and ACS and i would like to know how to enable the "Configuration Audit" for someone login to my network devices using their ACS login and i can monitor what they did on it.Appreciate if you could give me a simple steps .. tha...

I'm new to ACS 5.4 and have very limited knowledge of the previous versions. I am trying to get users in the external identity store (AD) to be dropped directly into enable mode after being authenticated, since I don't know of a way to set an enable ...

Good morning,I have configured my switch and ISE with this templatehttps://supportforums.cisco.com/docs/DOC-18325But i want the portal to second interface, if i change the advance attributes with the address https://ip(second interface):8443/guestpor...