Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am trying to update the c8000v device using Vmanage (version 20.15.4) API. The software 17.15.04.0.6839 has already been uploaded to vManage.
If i try the /device/action/image-download API i get an error to check the device input parameters???...
Hi all,i have an ISR and i have a a following scenario:On fa0/0 i have a static public IP address (ISP1) and on fa0/1 dynamic public ip address (ADSL-ISP2). I would like to use the ISP2 link for users conecting to Internet and the ISP1 link only as...
Hi, I have replaced "vmanage" with "remote" for "versionType" in both my API calls, and this time I see the task in the vManage for both API calls, but both times I get the same error "Please check the device action input parameters before re-trying"...
Hi Richard,thank you for your interest.I attached the config. I think the the static nat shoud be done using the route-map and i tried that but with no success.
Now i have a different problem Remote access VPN works with local PBR but in that example i didnt have the nat configured on that interface where the crypto map is configured. As soon as i put ip nat outside on that interface (because i have some sta...
