Network Access Control

Good afternoon cisco community, Recently our desktop support team approached in regards to getting bit locker networker unlock running to do WOL pushes to asleep machines. In our environment, we are currently in a full 'closed' deployment of  ISE wit...

Good afternoon communityDoes anyone have a documented procedure to perform a manual backup of ISE i.e exporting configuration elements via csv?At the moment we're unable to restore via a backup due to a bloated db hence the query.Ta 

Hi guys.New to this API call scripting malarky and need some assistance..  Basically im trying to change the access code on an ISE 3.2 guest portal.   I can pull the necesary varibles with the script below,  look at them,  convernt them to json etc, ...

Hi everyone,I'm facing some challenges while configuring Posture with closed mode and an IBNS 2 setup.First, is it possible to perform posture checks in closed mode?How did you manage port configuration and ACL/DACL settings?Should the ACL be used fo...

On VM I get the following error when enabling 802.1x on the switch port where the physical ESXi port is connected.  the multi-auth option is selected in ACI. AAA is configured on Cisco ISE with Windows as the default supplicant on VM's. Cisco ISE has...

During the install of Cisco ISE you are prompted for a username / password.  This account then appears to be the account you can use to SSH into ISE AND Web Auth to ISE.  My question is are these two seperate accounts that just happen to have the sam...

Hi all i`m using DNA and my company recently bougth ISE and we doing our implamantion o face problem with the Cisco Phone the problem it how to assigend Voice vlan to cisco phone when they try to connect using mab , becuse when i use authiz profile t...

Hi all, I have configured my ISE setup to validate certificates against a external OCSP responder but I do not get it to work.  The 802.1X certificates that my supplicants are using are issued by the external CA and my ISE setup has this certificate ...

Hello,I'm currently working on a project to migrate Cisco ISE (version 3.3.0.430 with Patch 2) from a VMware ESXi platform to Nutanix AHV.Is there an official procedure or specific recommendations from Cisco for migrating Cisco ISE from VMware to Nut...

Jan 30 17:11:56.881: %DOT1X-5-FAIL: Switch 1 R0/0: sessmgrd: Authentication failed for client (8cae.4cc6.58f6) with reason (Timeout) on Interface Gi2/0/29 AuditSessionID 035A170A000002F1B83067BE Username: anonymousJan 30 17:12:41.882: %DOT1X-5-FAIL: ...

We've seen a potential issue with the Administrative & Operational Audit logging categories, where a specific use case is not logged under the existing categories. Under the current codes we have: 51000 - Authentication Failure, 51001 - Authenticatio...

How does the TACACS dead timer work in the Cisco switch? Suppose you have this command"tacacs-server timeout 5"Does that mean if the switch doesn't get a reply within 5 seconds from the TACACS server, will that mark that server as "DEAD" and does not...