cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
966
Views
0
Helpful
2
Replies

Can ACS adds more Juniper RADIUS attributes?

sirote
Level 1
Level 1

Hi,

These Juniper RADIUS attributes supported by Cisco ACS4.0 by default

- Juniper-Local-User-Name

- Juniper-Allow-Commands

- Juniper-Deny-Commands

Is it possible to add more 2 attributes

- Juniper-Allow-Configuration

- Juniper-Deny-Configuration

Regards,

Sirote

1 Accepted Solution

Accepted Solutions

Jagdeep Gambhir
Level 10
Level 10

Hi Sirote,

On 4.0 the only way to add those attributes is to contact TAC and get the script directly from the developers.

This issue has been fixed in ACS 4.1.23

http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCsi18979&Submit=Search

If that answers your question, then please mark this thread as resolved, so that others can benefit from it.

Regards,

Jagdeep

View solution in original post

2 Replies 2

Jagdeep Gambhir
Level 10
Level 10

Hi Sirote,

On 4.0 the only way to add those attributes is to contact TAC and get the script directly from the developers.

This issue has been fixed in ACS 4.1.23

http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCsi18979&Submit=Search

If that answers your question, then please mark this thread as resolved, so that others can benefit from it.

Regards,

Jagdeep

Hi Jagdeep,

Thank you so much. That clarify my doubt.

Regards,

Sirote