Network Access Control

Cisco Identity Services Engine (ISE), Cisco Access Manager (CAM), Zero Trust Workplace
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other troubleshooting best practices.

Labels

Forum Posts

Resolved! ACS backup

Good afternoon. I am trying to back up an active ACS 4.1 SE 1113 appliance so that I can restore it to a test device that I have. I never realized that a backup on ACS can really be a bear. I have Quick'nEasy FTP server and have added login for acs...

dpatkins by Level 7
  • 694 Views
  • 1 replies
  • 0 Helpful votes

Hello, i just wanna ask the config to set AAA failover if ASA couldn't contact ACS. Is that possible? I want user access by authentcating to ACS but if ASA's connection to ACS fail, it will revert authentication to ASA itself.I see that ASA config is...

I have a setup where my VPN users hit the ACS server for user authentication - off of AD. What I am not sure of, is how to limit which users have VPN access. All of the users would still need to authenticate for wireless (EAP) but be limited to eit...

Can you help me to Understand that when I am adding aaa template to a switch which I am connected with telnet give me the error % Authorization failed and accounting part is not unable to be added. Also is unable to connect to this switch again. Eve...

adriatikb by Level 3
  • 870 Views
  • 1 replies
  • 0 Helpful votes

Hi List,I installed Cisco ACS 4.1 but when I'm configuring via GUI, suddenly after 5 min, the GUI session is disconnected, and I have to connected again, I don't know why the management session is disconnected if in Administration Control the Session...

omarept by Community Member
  • 702 Views
  • 1 replies
  • 0 Helpful votes