- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-28-2021 02:55 PM
When trying to delete AD connector on ISE, I get this error:
Referential Integrity error: This item is referred to by another object.
I deleted the policy set that uses the AD, but the behavior is still the same, is there a bug that addresses this? or is there something that I need to do first?
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-28-2021 03:33 PM
Hi @SMD28316
if you remove all the references then please open a TAC Case, TAC may help cleaning it up from the Database.
Hope this helps !!!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-28-2021 03:33 PM
Hi @SMD28316
if you remove all the references then please open a TAC Case, TAC may help cleaning it up from the Database.
Hope this helps !!!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-22-2022 10:46 AM
Hello SMD28316,
Did you ever get this resolved? If so, do you mind sharing root cause?
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-06-2022 03:38 AM
Hi,
The AD was used for admin access, after removing it the issue was fixed.
