This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC!
We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.
I am installing CDA (Context Directory Agent) version 1.0.0.011 on VMware for the first time and I am running into the following error:
***** Virtual Machine Host detected...
***** Error: Unable to detect size of hard disk(s)
***** Exiting installation
Running halt...
After that the installation halts and it says "you may safely reboot your system". I've confirmed that everything is setup correctly in VMWware. I am using a mounted ISO to perform install on a blank virtual disk. Not sure if there is anything special that I need to configure in VMWare to get this to work.
Solved! Go to Solution.
With all of the minimum requirements met and the correct OS is selected, this issue has been seen when the SCSI controller is set to VM Paravirtual. When the SCSI controller is changed to LSI Logic Parallel, the issue is no longer seen and yields successful installation of CDA.
Hi,
can you post a screenshot of your vm settings. also can you use the following as a reference. I also think there is a requirement regarding centos being set as the guest OS in the guide.
http://www.cisco.com/en/US/docs/security/ibf/cda_10/Install_Config_guide/cda_install.html#wp1053078
Thanks,
Sent from Cisco Technical Support iPad App
With all of the minimum requirements met and the correct OS is selected, this issue has been seen when the SCSI controller is set to VM Paravirtual. When the SCSI controller is changed to LSI Logic Parallel, the issue is no longer seen and yields successful installation of CDA.
Got the same Problem, with LSI Logic Parallel SCSI Controller.
My problem was the disk size, please note that this should be 30GB or more...
Regards,
Sven