07-23-2014 04:01 AM - edited 03-10-2019 09:53 PM
Hello everyone!
I urgently need your help please.
I would like to configure the ports of a switch for 802.1x.
when I type the command: Dot1x harbor auto-control on the interface, the protocol is down and users are disconnected wiring.
Can someone help me please? it is really urgent.
thank you in advance
07-24-2014 01:16 AM
Is this the command that you are using ?
"Dot1x harbor auto-control"
What else do you have for dot1x on this device?
Rate if Useful :)
Sharing knowledge makes you Immortal.
Regards,
Ed
07-24-2014 05:05 AM
hello
thank you for your answer.
bellow is the configuration that i've configured on the switchs:
configure terminal
aaa new-model
aaa authentication dot1x default group radius
!
interface fastethernet0/1
dot1x port-control auto
end
radius-server host x.x.x.x auth-port 1612 key xxxx
but the command : dot1x port-control auto , cause protocol dows but the port status is UP.
I did not understand the function of this command:"Dot1x harbor auto-control"
could you tell me a little more?
thank you in advance.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide