Cisco ACS 3.0 and PIX Authentication

[dione.vella]

Hi,

I am using a PIX 535 running version 6.3(1) and ACS to authenticate those users accessing the Internet.

My problem is that I have set the ACS server to allow only one session per user at any point in time. However it seems that this setting is being igonred either by the PIX or the ACS.

I am using Radius as my authentication protocol.

Can some one guide me through?

Thanks and regards

Dione

[jhillend]

MAX Sessions on ACS requires the use of accounting packets to determine when a user connects and disconnects from the network device. Turn on RADIUS or TACACS+ accounting (as appropriate) on your PIX. This should do the trick.

[dione.vella]

Thanks very much for your reply. That was it!!!