Cisco ACS Replica Database Problems
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2011 03:44 AM - edited 03-10-2019 05:58 PM
Hi,
I'm running Cisco ACS version 4.2 (patch 4.2.1.15.2) in a primary replica environment. I have the primary replicating to 3 replicas. On the primary, the ACS.db file is around 80MB.
However, on my replicas, the db file increases in size incrementally at every replication, until all of the available disk space is taken up (12GB)
The only way I've found to resolve this is to periodically uninstall/reinstall the aplpication on the replicas.
Has anyone experienced this issue with the replica database size increasing exponentially until disk failure, and found a resolution?
Many thanks in advance.
Andy
- Labels:
-
AAA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2011 03:53 AM
hi andrew,
does this happen on all three replication servers?
Regards,
Anisha
- do rate helpful posts.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2011 04:00 AM
Hi Anisha,
Yes this happens on all 3 replica servers, but the primary has no problems with db size
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2011 04:42 AM
Hi Andy,
Looks like there is some issue with your database and it is getting corrupt while replication.
Please open a TAC case and the engineer will look into it.
Regards,
Anisha
