Hi, I have recently installed Cisco CDA 1.0.0.011 patch 5 to test the functionality with Cisco ASA IBFW. I have successfully connected CDA to Microsoft AD and Cisco ASA and everything communicates well. The ACE I have created to deny traffic operates as expected.
The issue I have is that it takes about 10 minutes before the user/IP mapping is created in CDA, which means there is a delay before the ACL becomes active.
I have everything configured to default settings, is there some configuration required to shorten the time CDA needs to create the mapping?
Are there any recommended configurations?
Thanks in anticipation
Regards
Dale Shaw