09-25-2018 01:31 AM - edited 03-11-2019 01:49 AM
Hi, all.
We installed 2.2 patch 10 a few days ago, since then thousands of alarm messages were thrown, like:
"Replication failed", "health status unavailable", etc., all sounding like the nodes could not see each other anymore.
In addition to that, the "System Summary" applet on the deployment homepage showed all nodes in grey, all with
"no Data available" .... function of the deployment did not seem affected at all though....
After rollback of patch 10 (to patch 9), everything seems back to normal, no large numbers of the alarms I mentioned and
the system summary applet shows normal stuff again, too.
Something like that never happened with any other patch before (1-9), I strongly believe that this was not supposed to happen
with patch 10 either. :-)
Anybody had a similar experience ???
Rgs
Frank
Solved! Go to Solution.
09-25-2018 03:58 AM
09-25-2018 05:38 AM
I was browsing the communities this morning to see if there had been anybody to install patch 10 yet. Sorry to hear this, you'll have to let us know what you figure out after engaging TAC.
Also, you may get more visibility posting here instead - https://community.cisco.com/t5/identity-services-engine-ise/bd-p/5301j-disc-ise
09-25-2018 03:58 AM
09-25-2018 05:38 AM
I was browsing the communities this morning to see if there had been anybody to install patch 10 yet. Sorry to hear this, you'll have to let us know what you figure out after engaging TAC.
Also, you may get more visibility posting here instead - https://community.cisco.com/t5/identity-services-engine-ise/bd-p/5301j-disc-ise
09-25-2018 05:48 AM
09-25-2018 05:54 AM
Yepp, my bad, I posted in the wrong place, sorry .....
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide