Cisco ISE and WLC Radius

[Andy Guley]

I am running Cisco ISE 2.0 Patch 2 and the virtual WLC code is 8.2.100. In ISE clients are authenticating to radius and hitting the right authentication and authorization rule.  My Windows client never gets and IP and says it fails when its trying to connect to the SSID.  The ACL that I created on the WLC shows zero hits on it as well. Any thoughts or suggestions on why the Windows client is not connecting would be appreciated. 

Thanks

[Joseph Johnson]

Do you have DHCP Addr Assignment Required enabled on the WLAN (advanced tab)? If so, try disabling it. I've had that issue before and that was the quick workaround.

[Andy Guley]

I do not have it enabled.