Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to do an ISSU upgrade of my 93108 switch. The switch is in NXOS mode. I am getting getting the following error on the upgrade check: Installer will perform impact only check. Please wait. Pre-upgrade check failed. Return code 0x4093008A...
Currently we are in the process of migrating our legacy 7k/5k/2k environment to VXLAN EVPN. We have our 7k enviornment connected to two border gateways. We are connected at layer 2 (VPC) and layer3 (BGP). We have a desire to move SVI's before we m...
I am in the process of going through a core switch migration. Currently we run the 3 Tier model. 7k 5K 2K. We are using OTV as a DCI as well. We are exploring and want to go the VXLAN EVPN route. We have already purchased a bunch of 9k switches....
Is there a way in the ASA to point to a file to update an ACL? Palo Alto has an option to do this. Is there an equivalent in the ASA? https://docs.paloaltonetworks.com/pan-os/8-0/pan-os-admin/policy/use-an-external-dynamic-list-in-policy/configure-...
I am looking for a good configuration example for utilizing eBGP and am struggling to find a good example anywhere. Does anyone have an example for using eBGP over DMVPN? Thanks
This is the doc I am working off of to push AnyConnect from ISE.
https://hainc.com/2019/01/11/blog/how-to-update-anyconnect-compliance-modules-on-cisco-identity-services-engine-ise
Here is the full ACL I usually run on my outside interface at my remote sites:
Extended IP access list OUTSIDE_ACCESS_IN 11 permit udp any host x.x.x.x eq non500-isakmp (DMVPN) 12 permit udp any host x.x.x.x eq isakmp (DMVPN) 13 permit e...
I don't have the entire configuration in front of me right now. I was just some more reading and it appears that you cant have the ACL on the outside interface? Would you agree with that?
policy-map type inspect INSIDE-TO-OUTSIDE-POLICY
class typ...
Jon,
Finally got DMVPN implemented and everything is working as expected. My DMVPN router is running EIGRP 100 and 200 processes. My core switch is running EIGRP 100. On my DMVPN router I am redistributing 100 into 200 and 200 into 100. My remote...
Has anyone else seen this issue? I am having almost the exact same problem.
1. If the headset is not hooked up the phone powers fine2. If the headset is hooked up with an aux cable and no usb cable into the headset the phone powers fine3. If the he...
