cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
452
Views
3
Helpful
3
Replies

CISCO ISE authentication configuration option has disappeared

TED07
Level 1
Level 1

 

Hi,

I have a problem does anybody knows what is casuing  this issue i cannot edit my authentication rules after saving it has anybody had similar problem before ?

Version:
3.4.0.608
thanks.
1 Accepted Solution

Accepted Solutions

Scott Fella
Hall of Fame
Hall of Fame

I ran into this bug, in which I had to recreate my policy because I was unable to see and edit my policy.

https://bst.cisco.com/bugsearch/bug/CSCwo03350?rfs=qvred

-Scott
*** Please rate helpful posts ***

View solution in original post

3 Replies 3

Scott Fella
Hall of Fame
Hall of Fame

I ran into this bug, in which I had to recreate my policy because I was unable to see and edit my policy.

https://bst.cisco.com/bugsearch/bug/CSCwo03350?rfs=qvred

-Scott
*** Please rate helpful posts ***

Arne Bier
VIP
VIP

I have never run into this terrible bug - and I always use a Deny in my default Authentication Rules. I thought this was a bug that used to exist in ISE 2.x when a similar issue happened from 1.x to 2.x upgrades - the conversion process would create more config than needed due to this. The trick was to not use "Deny Access" in Authentication Rules prior to the migration. But those were the bad old days. You can't expect customers NOT to use "Deny Access" in Authentication Rules   

Yeah it wasn’t fun. I had to export the policies in xml and build them again from scratch. So really didn’t know when it broke. I just wanted to show a peer the polices so they understood it and I got DENIED:)
-Scott
*** Please rate helpful posts ***