Cisco ISE backup & restore not working in GUI after upgrade from 1.4 to 2.0p2
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-19-2016 07:37 AM - edited 03-10-2019 11:30 PM
Hi,
After upgrading a Cisco ISE 1.4 distributed installation to 2.0p2 I am no longer able to do backups from the GUI. When going to the backup & restore page the "backup now" button is greyed out and no information is available on the page.
If I leave the browser at the page for 5-10 minutes the information about the last backup appears but when trying to do a backup it just gets stuck. I have tried switching browsers/flash version but the problem is unchanged.
Backing up from CLI works fine.
Does anyone have a solution for this?
Thanks in advance!
- Labels:
-
AAA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-19-2016 07:58 AM
Have you tried different browsers or reloading the system again?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-20-2016 05:29 AM
Yes, tried with Firefox, IE and Chrome and have reloaded the system, promoted secondary admin to primary and back (thought that something may have gone wrong when the personas where switched during upgrade) and reverted back to 2.0 from p2 with the same problem still....
