03-21-2012 01:02 AM - edited 03-10-2019 06:55 PM
Hello Guys,
CWA is not working. It says that authentication suceeded but posture status is pending. No error in my Monitor--authentication. Checking it in my Windows 7, it does not shows the CWA portal.
What might be the possible problem of this.?
thanks
03-24-2012 03:23 AM
There are a lot of possible causes.
Are you doing CWA over wired or wireless ?
can you post a screenshot of your authorization policy on ISE ? your switch config ?
btw, posture status is unrelated. It can stay pending and everything to work fine.
03-24-2012 06:29 AM
Hello,
I am doing it in wired. Anyways, solve it already, I used the cisco configuration from cisco. Now, I will be doing the wireless CWA.
Anyways, thanks for the reply.
regards
04-10-2013 12:42 AM
hi
are you able to share how this was fixed i am getting the same problem...which document did yo use.
04-10-2013 01:50 AM
04-10-2013 01:57 AM
This link is much more up to date :
http://www.cisco.com/en/US/products/ps11640/products_configuration_example09186a0080ba6514.shtml
04-10-2013 05:14 PM
i have followed the doc to the dot. the only other theing i can think of is that i hav got profiling on.CoA is set to re-auth
i pass mab, get to the guest portal, log in using guest credentials, but then i dont get a new IP in the guest vlan. my ip address on the switch logs remain in the data vlan, it should change to a guest vlan.
05-15-2013 02:36 AM
09-12-2013 02:36 AM
Here is a best document for Central Web Authentication (CWA) for guests with ISE, Please check:
09-12-2013 10:06 AM
I would suggest you to go to below link
http://www.cisco.com/en/US/products/ps10315/products_tech_note09186a0080a38c11.shtml
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide