Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1616
Views
0
Helpful
0
Replies

CISCO ISE: how to configure a DACL with an IP adress ranges to apply on a CISCO ASA

Cisco Service ENTIRETEC
Level 1
Level 1

‎06-06-2018 06:30 PM - edited ‎02-21-2020 10:57 AM

Hi all,

sorry, but I've asked this question a few days ago but my post is vanished.

Is it possible to configure an IP address range within an DACL for a ASA55xx?

I'm aware to use a dedicated subnet mask 'if possible' but is there any other way like a port range command?

permit tcp any host 1.1.1.1 range 1024 2024

1 person had this problem
Labels:
0 Helpful
0 Replies 0
Customers Also Viewed These Support Documents