Cisco ISE - line posture node and switch connection.

[ivan.chien]

I am studying how Cisco ISE - Inline Posture Node working under the Bridge Mode. I learned that I need to configure the vlan mapping between the untrusted and trusted interfaces of IPN device ( http://www.cisco.com/en/US/docs/security/ise/1.1/user_guide/ise_ipep_deploy.html - Figure 10-6).

Does that mean I can setup a 802.1Q trunk link between the switch port and trusted/untrusted interface on IPN? Is there any vlan mapping entry limitation? Thanks.

[vikasyad]

Please review the below link which might also be  helpful:

http://www.cisco.com/en/US/products/ps11640/products_configuration_example09186a0080bea904.shtml