Cisco ISE Virtual Appliance IP Change

[rashish135@yahoo.co.in]

Hi

We have bunch of Cisco ISE virtual appliance with software version 2.6 and smart license installed. We have 2 PAN & PSN (Pri & Sec) and couple of PSN. Out of this we have to move one of the PAN to new VLAN with new IP address.

Please advise whether we can change the ISE IP address or not and if it is possible, please guide how to do it.

Regards

Ashish Shah

[balaji.bandi]

you need to de-register and change the IP address - config rest and join the node back.

[Mike.Cifelli]

FYSA...additional info, every IP change triggers service restarts.

[Damien Miller · Accepted solution]

I would recommend using the "reset-config" command from the console (won't run via SSH). This will run you through all of the network configuration setup again. This command will only run if you first deregister the node from the primary PAN so you should do this in a maintenance window because the node will not be authenticating endpoints.  

Eddie's example
https://community.cisco.com/t5/security-blogs/reset-ise-host-os-config-with-a-single-cli/ba-p/3660180

[rashish135@yahoo.co.in]

Hi

Thanks for helping. Its really helpful. 

Regards

Ashish Shah