cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1600
Views
45
Helpful
4
Replies

Cisco ISE vm large and vm medium can join ha ?

jewfcb001
Level 4
Level 4

Hi all

I would like to know Cisco ISE 2.7 VM large can join different cisco ise vm medium or not ?

1 Accepted Solution

Accepted Solutions

Hi, 

 

yes it possible to do. but recommendation is to have same size VMs for primary and secondary which helps to keep stable solution with good performance. check below link.

 

https://community.cisco.com/t5/network-access-control/can-i-mix-amp-match-appliance-types-in-a-cisco-ise-gt-2-4/td-p/4020174

 

rate this and mark as an answer if this solved your concern

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB

View solution in original post

4 Replies 4

Hi, 

 

yes it possible to do. but recommendation is to have same size VMs for primary and secondary which helps to keep stable solution with good performance. check below link.

 

https://community.cisco.com/t5/network-access-control/can-i-mix-amp-match-appliance-types-in-a-cisco-ise-gt-2-4/td-p/4020174

 

rate this and mark as an answer if this solved your concern

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB

@Kasun Bandara 

 

Thank you for your answer .

 

My understand Primary and Secondary node must be same resource but Policy node can mix vm resource . My understanding correct ? 

So If my understanding correct. I can  deploy new policy node to mix resource and join existing distribute deployment . 

Please confirm me again . 

Hi @jewfcb001 

 

yes you are right. better keep differences between nodes as minimum as possible to maintain performance in case of failure.

 

rate this and mark as answer if this resolved your concern

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB