- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2025 03:08 AM
Hi Community Members,
Recently I came across high utilization on my ISE VM (PSN) node running version 3.3 patch 4. To diagnose the issue TAC was engaged and as per the recommendation from TAC I need to increase RAM size from 32Gb to 96Gb for which I have to shutdown the ISE VM. A little confusion over using both commands or single command i.e. application stop ise or halt. Pls suggest should I use both or any one of them would do the job.
Regards,
MT
Solved! Go to Solution.
- Labels:
-
Identity Services Engine (ISE)
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2025 03:14 AM
- If you gracefully shutdown an ISE node from the CLI with "application stop ise", then the "halt" command, this node will boot up with it's data intact ; so it's important to have both commands executed in that order , the first one stops the ISE apps first,
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2025 03:14 AM
- If you gracefully shutdown an ISE node from the CLI with "application stop ise", then the "halt" command, this node will boot up with it's data intact ; so it's important to have both commands executed in that order , the first one stops the ISE apps first,
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2025 05:08 AM
Thanks @marce1000 for the clarification. Once the memory upgrade is completed I only have to issue application start ise to start the VM right ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2025 06:03 AM
-:You only need to power on the VM. ISE will then start automatically : check the status of ISE afterwards with :
show application status ise
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
