- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-13-2023 11:44 AM
All,
I am looking for documentation or steps to modify the default TACACS timeout configuration, as we are implementing the MFA (Mutli Factor Authentication) for authentication it is getting a timeout. I believe the default timeout is 5 Sec. We would like to increase to 30 Sec. However I cannot find any documentation on this topic. I have referred to the below one.
Kindly help
Thanks
Solved! Go to Solution.
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-13-2023 04:12 PM
This question would be better placed in the NFVIS Solutions Community page. This NAC Community is mainly focused on Cisco ISE.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-13-2023 04:12 PM
This question would be better placed in the NFVIS Solutions Community page. This NAC Community is mainly focused on Cisco ISE.
