CiscoSecure ACS 4.0

[gbiettler]

I'm currently setting up a CiscoSecure ACS 4.0 using TACACS+. I want to set the login up so when I login into a switch/router I automaticly login into the enable mode at the same time. Is this possiable??

I've used other TACACS+ servers that have the ability to do this but don't see it on Cisco's

Thanks in advance!

[darpotter]

Hi

You can set individual enable passwords within each user record in ACS. You have to switch on user level advanced T+ features in interface config first.

You can set the enable password to be the same as the primary (internal or external, eg CSDB or windows) or some other value.

If the router automatically does an enable login after the session login, ACS will authenticate both.

But thats controlled by the device - not ACS

Darran

[jhillend]

Try the following URL:

http://www.cisco.com/en/US/partner/tech/tk59/technologies_tech_note09186a008009465c.shtml