CiscoWorks LMS + Radius

[BABARCHE]

Hi,

I'm trying to use radius with ciscoworks LMS. No problem to log in LMS.

But with RME, it does not work. When I "Change devices attributes", I have possibility to enter tacacs username/password or local username/password, but no radius authentication is possible.

So, RME is not able to connect to the switch with telnet ("check devices attributes" fails !). Then I'm not able to use netconfig or configeditor.

Any idea to solve this problem ?

The radius server is a RSA ACE v5 used with security token.

Thanx !

Bastien.

[umedryk]

Hi Bastien,

When adding the device to RME Inventory, enter your radius username/password in the TACACS username/password fields. You should also enter an Enable Secret password. If you go directly to enable mode and don't need to enter and enable password, then only enter into the TACACS

Enable username/password fields.