Configuration of different Wireless Networks in ISE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-27-2021 06:08 AM
Hi,
we have Cisco AIR-Ap2802l-E-K9 as access points and an Aironet 2800 Series Mobility Express as a controller.
How do you configure the networks with ISE or Wireless Controller so that:
- a guest WIFI has Internet but cannot access the internal network.
- a separate WIFI has access to the internal network but no Internet.
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-27-2021 06:53 AM
There are a lot of components in play here to fully answer this question. You can definitely accomplish your end goals. I suggest starting with the following resources to gather a better understanding of what needs to occur from a design/deployment perspective (specifically the Guest and Secure Wireless Access section):
Cisco ISE & NAC Resources - Cisco Community
HTH!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-30-2021 03:15 AM
Thank you for your reply.
Unfortunately, the ISE documentation is very extensive and complex, especially for users who have never worked with it before.
Can you steer me in the right direction as to what steps are necessary to achieve the objectives mentioned?
Kind regards
