cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2377
Views
5
Helpful
1
Replies

'cts manual' command on port-channel

Josh Morris
Level 3
Level 3

I am trying to enable TrustSec in my environment. I need to get the 'cts manual' command on all my uplinks in order to propagate SGTs. My issue is that all my uplinks are port-channels. You can't add cts manual to port-channels. So far, I've had to remove the interfaces from the port-channels, add the commands on both sides, then re-add the interfaces to the port-channel. This causes an outage. Is there a better way to do this? Thanks.

1 Reply 1

lburleso
Level 1
Level 1

Platform: 3850 IPBase

I was able to work around the problem by creating a new port-channel, removing a member port from the old PC, modifying it, and adding to the new PC.  The far end is VPC pair of Nexus 5k.