Solved: Re: Device Import : Empty TACACS Section

InTheJuniverse · ‎03-03-2019

Hello

I am trying to import devices into ISE 2.4, everything works fine except that the imported devices don't have any Authentication protocol selected (in my case TACACS), though the TACACS shared secret is imported!!

What am I doing wrong? Oh btw, I have exported few devices from ISE and using the same template for import.

Thank you.

InTheJuniverse · ‎03-03-2019

Thank you. I read that before posting and my issue was different.

I could import the devices without errors, but 'TACACS Authentication Settings' was unchecked as you can see in the screenshot.

Funnily enough, I had to set column AO "TACACS:Connect Mode Options:String (OFF|ON_LEGACY|ON_DRAFT_COMPLIANT)" to OFF in order to enable TACACS Authentication for import :) :) :)

View solution in original post

marce1000 · ‎03-03-2019

- Check the discussion from the thread below :

https://community.cisco.com/t5/policy-and-access/import-network-devices-into-ise-2-4-authentication-protocol/td-p/3378317

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

InTheJuniverse · ‎03-03-2019

Thank you. I read that before posting and my issue was different.

I could import the devices without errors, but 'TACACS Authentication Settings' was unchecked as you can see in the screenshot.

Funnily enough, I had to set column AO "TACACS:Connect Mode Options:String (OFF|ON_LEGACY|ON_DRAFT_COMPLIANT)" to OFF in order to enable TACACS Authentication for import :) :) :)