Disk failure not showing in GUI

[Jithishkkuttappan]

Hi,

Why we are not able to get alerts on disk failure in ISE GUI 2.2 version.

How we can proactively monitoring the Disc in ISE Nodes?

[Greg Gibbs]

If you need more information than what is available in the built-in Alarms, you would need to look at monitoring the ISE application or hardware appliances via SNMP traps or polling. See the following links for more information and options:

SNMP Traps to Monitor ISE

Monitoring ISE health using SNMP Polling 

[Arne Bier]

If you are talking about the ISE SNS hardware appliances, then you should configure SNMP trap receivers in the CIMC. You can also set up email alerts.

ISE only supports a single configurable SNMP trap (when available disk space space reaches a configured threshold)

SYSLOG is another mechanism - CIMC supports sending to up to two SYSLOG servers

[Damien Miller]

Someone should feature request Cisco Intersight adding the SNS appliances to the monitoring templates. Intersight base licenses are free.