cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4432
Views
5
Helpful
3
Replies

EAP type not configured

mirboukai
Beginner
Beginner

hi

i have an ACS 1113 ....

i have installed and configured the certificate... and trusted the CA certificate... also i configured the global authentication (enable the PEAP ,EAP-TLS)

no when i try to authenticate (by the wireless) i get failed to authenticate

when checking the ACS failed attempts i find the failure code

- EAP type not configured-

i don?t know why its happing....

but every thing is configured...

3 Replies 3

Jagdeep Gambhir
Advocate
Advocate

Please make sure on ACS > Network Access Profiles >

Make sure we have "Grant access using global configuration,when no profile matches" option

selected.

Also make sure on ACS > ACS Certificate Setup > Install ACS Certificate >

Make sure a certificate is installed, if it is installed then click cancel.

Also go to ACS > System Configuration > Global Authentication Setup > Make sure under "PEAP" we have checked "Allow EAP-MSCHAPv2" and/or "Allow EAP-GTC" as applicable.

Regards,

~JG

thank you

the "Grant access using global configuration,when no profile matches" option was not selected.

could you please give me a brief of why do we configure the NAP..

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers