Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hii want to upgrade the acs(windows) from 4.1.1 to 4.1.4 or 4.2 there is 1 document i know ... it says---------------------------------ACS 4.1.1.23 or ACS 4.1.1.24 to ACS 4.1.3 or ACS 4.1.can upgrade from ACS 4.1.1.23, 4.1.1.24, to ACS 4.1.3 or 4.1.4...
hii have an ACS 1113 ....i have installed and configured the certificate... and trusted the CA certificate... also i configured the global authentication (enable the PEAP ,EAP-TLS)no when i try to authenticate (by the wireless) i get failed to authen...
hi i have a wcs and how can i mantain the wireless coverage through the wsc plan?(( i mean i dont want the wirless coverage to do out the building edge))((i have put the plan and assigned the access point on them))
hii have a Lightweight Access point that connected to a non POE switch.and its tacking the power from the power injector.Is there any problem will appear when I change the configuration at the controller (( it will ask to reboot the access point)) bu...
thank youthe "Grant access using global configuration,when no profile matches" option was not selected. could you please give me a brief of why do we configure the NAP..
Thank you... that was really helpful I have another problem ... I wonder if you could help me....http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Wireless%20-%20Mobility&topic=Security%20and%20Network%20Management&CommCmd=MB%3Fcmd%3D...
HiThanks for your help...But in this way I will re-assign the power and channel manually ... I though we could do it automatically by the WCS just telling him that we want no coverage out side the building edge
