Hello everyone! How are you?
I am performing some tests on my network by integrating an AP305C from Extreme Networks with Cisco ISE to perform corporate network authentication and later for guest networks.
Can anyone who has already done this configuration guide me or direct me on how it was configured on the ISE side to support this third-party equipment? I have already imported the Extreme dictionary and followed other documents, but without success.
Base link: https://community.cisco.com/t5/security-knowledge-base/ise-2-4-posture-using-snmp-coa-with-extreme-switches/ta-p/3641460
If anyone has done this and can support me, I would be grateful.