01-09-2013 12:29 PM - edited 03-10-2019 07:57 PM
Having an issue where a user will plug a PC into a switch. The switch does a MAB authenticaiton and the MAC is not located in the ACS server. It logs the failed attempt, but when the PC is removed from the switch, the failed attempts keep getting logged until the port is bounced. Any way to keep the attemps from happening after the PC is removed? If not, any way to make it stop without bouncing the port?
running ACS ver. 5.2.0.26
switch port config:
interface GigabitEthernet1/0/2
sw access vlan 2 sw mode access
authentication control-direction in
authenticaion host-mode multi-auth
authentication port-control auto
mab
spanning-tree portfast
01-09-2013 01:29 PM
Hi,
What version and code is your switch?
Thanks,
Tarik Admani
*Please rate helpful posts*
01-10-2013 04:46 AM
running IOS 12.2(55)SE1
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: