08-24-2004 05:21 PM - edited 03-10-2019 01:46 PM
In group setup only appear 100 groups instead of 500.
Is there any procedure to have the 500 groups in Group Setup?
Solved! Go to Solution.
08-27-2004 07:34 AM
You do of course need to have admin access to all the groups;
Check in Administration Control, Click your username, under administrator privileges make sure all the 'available groups' are in the 'editable groups' list box.
That should probably solve your issue.
08-25-2004 03:07 AM
Cisco Secure ACS dynamically builds the Group Setup section interface depending on the configuration of your network devices and the security protocols being used. That is, what you see under Group Setup is affected by both your system's network configuration and your settings in the Interface Configuration section.
08-25-2004 06:03 AM
I use same configuration (restore .dmp file, ) and interface options in other Cisco Secure v3.2.
I can see 500 groups.
How can I increase the group number from 100 to 500?
08-27-2004 07:34 AM
You do of course need to have admin access to all the groups;
Check in Administration Control, Click your username, under administrator privileges make sure all the 'available groups' are in the 'editable groups' list box.
That should probably solve your issue.
09-02-2004 09:44 AM
Thanks, now its working fine
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide