How do I edit multiple groups in Secure ACS?

[jack.leung]

Say I have 20 or so user groups with in ACS and I want to modify one field in all of them (say I want to change the [3076\005] Primary-DNS field in all of them to have the same). Is there a way to do this in one shot (either through upload a txt using csutils??) or would I need to edit this one group at a time?

[smalkeric]

You can change the Cisco Secure ACS group to which a group set mapping is mapped.

Note: The external user database groups of an existing group set mapping cannot be edited. If you want to add or remove external user database groups from the group set mapping, delete the group set mapping and create one with the revised set of groups.

To edit a Windows, Novell NDS, or generic LDAP group mapping, follow the steps in the URL:

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_windows/3.3/user/guide/qg.html#wp940637

[jack.leung]

That wasn't my question though... I have multiple ACS groups (Group Setup -> Group 1, 2, 3, 4 , etc) and I was asking if there were a way to modify one attribute in all of the groups instead of going through one by one.

[ansalaza · Accepted solution]

There is an Action Code (163 - ADD_RADIUS_ ATTR) in RDBMS, but it would only modify IETF RADIUS Attributes.

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_windows/4.2/user/guide/A_RDBMS.html#wp78074

I don't beleive there is any option to accomplish what you are trying to do...

You will need to go one by one into each Group and make the required changes.