06-06-2018 11:37 PM - edited 02-21-2020 10:57 AM
How to apply multiple Frame-Route via Cisco ISE
I have devices authenticating and getting an IP address applied via Cisco ISE.
Now I want to advertise routes from the the authenticated devices via Cisco ISE using the RADIUS attribute 22 (RADIUS:Framed-Route).
I currently can apply an individual Framed-Route successfully but need to advertise multiple routes fromt he devices, is this possible.
Any help is greatly appreciated.
Cheers.
Solved! Go to Solution.
07-23-2019 12:54 AM
I applied a single address to the end point and using that address did a NAT overload on the address to connect into the network.
Later when this was working for a while I created GRE tunnels to the addresses and advertised the network routes through these tunnels.
07-23-2019 12:54 AM
I applied a single address to the end point and using that address did a NAT overload on the address to connect into the network.
Later when this was working for a while I created GRE tunnels to the addresses and advertised the network routes through these tunnels.
10-22-2019 11:14 PM - edited 10-22-2019 11:17 PM
Hi
10-22-2019 11:17 PM
Hello,
I'm about to implement the same policy for LTE platform.
Could you please share the policy for Authentication and Authorization.
Thank you
10-24-2019 03:22 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: