Hi,
We are using cisco 3560x switch, then connect Meraki MR34 Access port for ISE 2.3 project.
For the switch interface between 3560x switch and Meraki AP,if I enable dot1.x and MAB on this interface, I always have lots COA failure messages. If disable dot1.x and MAB, the looks COA failure disappeared. (maybe it is a bug,i do not have time to log case at moment)
If disable dot1.x MAB on this interface, when "show auth session", i can not see any information.
so, what is the best configuration for this interface?
thanks