- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-18-2016 04:51 AM
When we issue a ISE PSN backup (via CLI) or if we need to consult the ISE config, we get an encrypted file (eg : « EU_NAC-CFG-160716-0200.tar.gpg »
We do not know how to read it. Even with the key.
Is it possible to read this file? (without using graphic interface)
Solved! Go to Solution.
- Labels:
-
Identity Services Engine (ISE)
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-19-2016 08:42 AM
Jerome,
The backup file is encrypted via GPG. To decrypt it you need the key that was specified at the time of backup. Once decrypted, you will have an archive file (TAR) that you can expand to see the contents.
Regards,
-Tim

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-19-2016 08:42 AM
Jerome,
The backup file is encrypted via GPG. To decrypt it you need the key that was specified at the time of backup. Once decrypted, you will have an archive file (TAR) that you can expand to see the contents.
Regards,
-Tim
