I cant ping my PC from cisco ASA

[malmjally]

Hello everyone, 

I have a virtual ASA using VMware:

the ASA is using the following interface: VMnet1 10.0.0.200 Interface g 0/0 is set to 10.0.0.100

My loop-back interface is: 10.0.0.150

I can successfully ping the IP 10.0.0.100 from my PC but not the other way around, and I can see the page https://10.0.0.100/admin/public/index.html

But when I try to access ASDM I get the error:

unable to launch device manager from 10.0.0.100

please help !!!

[Flavio Miranda]

Hi @malmjally

 If you can ping the firewall then ok. 

A few steps you need to went through:

On ASA:

http  'PC's IP address'  'Mask'    inside   

This permit you PC to connect to the ASA.

But most important, you need to edit your Java configuration on your PC. Lower the security level for "low" and add the ASA IP address as trusted IP address.

 See attached.

-If I helped you somehow, please, rate it as useful.-

[malmjally]

thank you Flavio Miranda for your replay

I tried the following command:

enable http server

http10.0.0.150 255.255.255.0 inside

and I still get the same error !

the IP 10.0.0.150 is the loopback interface IP, what do you think I should do?

[Flavio Miranda · Accepted solution]

Do this:

http 0.0.0.0 0.0.0.0  inside

Then, try to access the inside IP not loopback.

 Take a look on Java as I said.

-If I helped you somehow, please, rate it as useful.-

[malmjally]

@Flavio Miranda
I cant thankyou enough it worked !
God bless you

[Flavio Miranda]

You're welcome.

Takes for rating.

-If I helped you somehow, please, rate it as useful.-