cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
972
Views
0
Helpful
2
Replies

If database of ACS full,we will cannot login ACS,right or not?

HI everyone,


we have met a problem,that is about database useage,we can issue "acsview show-dbsize"command in acs-config mode,but we cannot see any output about database.

So,i want to know whether there will cannot login ACS in case the database full?


ACS verison:5.5.0.46.


thanks a lot.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !
2 Accepted Solutions

Accepted Solutions

Jason Kunst
Cisco Employee
Cisco Employee
What’s wrong with info in this post? If you still need answer please update that thread

https://community.cisco.com/t5/policy-and-access/what-will-happen-if-acs-database-full/td-p/3743380

View solution in original post

I have already learned about this problem.

After the ACS Appliance 5.x acts as the log collector, if it does not perform reasonable database compression or data backup operations for a long time, it will cause nearly 100% of the space in the /opt directory of the system file to be occupied. It is a key directory for ACS applications and will extend a series of problems, such as the service is in the hang state, and the WEB GUI page cannot be opened normally.

we can do it as below:
Confirm the problem---backup or dump data---clean up space-optimized configuration After logging in to the ACS through the CLI, you can quickly get the health status of the current ACS disk space through the "show disk" command, after confirming that the disk space indicator is deteriorating , arrange the following steps to implement step by step.

refer to :https://www.cisco.com/c/zh_cn/support/docs/security/secure-access-control-system/processdiskfullforacsoptdirectory.html
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !

View solution in original post

2 Replies 2

Jason Kunst
Cisco Employee
Cisco Employee
What’s wrong with info in this post? If you still need answer please update that thread

https://community.cisco.com/t5/policy-and-access/what-will-happen-if-acs-database-full/td-p/3743380

I have already learned about this problem.

After the ACS Appliance 5.x acts as the log collector, if it does not perform reasonable database compression or data backup operations for a long time, it will cause nearly 100% of the space in the /opt directory of the system file to be occupied. It is a key directory for ACS applications and will extend a series of problems, such as the service is in the hang state, and the WEB GUI page cannot be opened normally.

we can do it as below:
Confirm the problem---backup or dump data---clean up space-optimized configuration After logging in to the ACS through the CLI, you can quickly get the health status of the current ACS disk space through the "show disk" command, after confirming that the disk space indicator is deteriorating , arrange the following steps to implement step by step.

refer to :https://www.cisco.com/c/zh_cn/support/docs/security/secure-access-control-system/processdiskfullforacsoptdirectory.html
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !